Gas Detector

Catalogue

The gas detectors are stationary, continuously working control devices to which sensors for the measurement of toxic gases can be connected.

The devices stand out for their reliability and the low
installation and maintenance work required.

They can be used in industrial and private applications.

Sensor connection
The sensors are connected via a shielded two-wire line.

The sensor enclosure accommodates the electrochemical sensor and the sensor PCB. The sensor receives the measured signal and the printed circuit board converts it into a 4...20mA signal.

At the same time the PCB is supplied via the same line with a 24 V DC auxiliary voltage. For this reason sensors with an external power supply must not be connected.

Please make sure that every sensor is shielded when the gas detector system is installed. Only then can immunity from interference be guaranteed for the detector.